Chapter 4 IP Testing
Configuring layer 3 IP tests
148
HST-3000 Ethernet Testing User’s Guide
Specifying IPv6
filter criteria
To specify IPv6 filter criteria
1 If you haven’t already done so, launch your IPv6 applica-
tion (see “Launching an application” on page 28), and
then select a test (see the appropriate procedure below):
– “Selecting a layer 3 IP test” on page 120
– “Selecting a layer 4 TCP/UDP test” on page 165
2 Press the Configure navigation key.
A configuration menu appears.
3 Do the following:
a Use the left and right arrow keys to go to the IP Filter
menu (see Figure 31).
Figure 31 IP Filter configuration menu (IPv6 settings)
To Next Page
Loading...
