Chapter 4 IP Testing
Configuring layer 3 IP tests
HST-3000 Ethernet Testing User’s Guide
149
b Specify values for the following settings:
Setting Parameters
IPv6 Filter Select one of the follow-
ing:
– If you want to filter
received traffic using
layer 3 IPv6 criteria,
select Enable.
– If you do not want to
filter received traffic
using layer 3 IPv6 cri-
teria, select Disable.
IP Version
(if IPv6 Filter is enabled, and
Monitor/Thru application was
selected)
Select one of the follow-
ing:
– To monitor all received
IP traffic (with IPv4
and IPv6 headers),
select Don’t Care.
– If you want to monitor
received IPv4 traffic,
select IPv4.
– If you want to monitor
received IPv6 traffic,
select IPv6.
Specify Source
(if IPv6 Filter is enabled)
– To analyze received
packets from any IP
address, select
Don’t Care.
– To analyze packets
sent from a specific IP
address, select Yes.
To Next Page
Loading...
