JDS Uniphase HST-3000 - Page 172

Chapter 4 IP Testing
Configuring layer 3 IP tests
150 HST-3000 Ethernet Testing User’s Guide
Source IP
(if Specify Source is Yes)
Enter the source address
carried by filtered packets.
NOTE:
If you want to use this
address to filter traffic
coming from or going to
this address, specify
Either Direction as the
Address Filter.
Source Prefix
(if Specify Source is Yes)
– To analyze received
packets for a specific
source IP address,
select None. Packets
with a source address
that matches the
address you specified
as the Source IP filter
setting will be ana-
lyzed.
– To analyze packets
that match specific
prefix criteria, select
Prefix, and then spec-
ify the length of the
prefix that you want
the filter to evaluate.
Only packets that
match the prefix por-
tion of the source IP
address (up to the
length that you speci-
fied) will pass through
the filter for analysis.
Setting Parameters