Chapter 4 IP Testing
Configuring layer 3 IP tests
HST-3000 Ethernet Testing User’s Guide
151
Specify Dest
(if IPv6 Filter is enabled)
– To analyze received
packets sent to any IP
address, select
Don’t Care.
– To analyze packets
sent to a specific IP
address, select Yes.
Destination IP Enter the destination
address carried by filtered
packets.
Destination Prefix Select one of the follow-
ing:
– To analyze received
packets sent to a spe-
cific destination IP
address, select None.
Packets with a desti-
nation address that
matches the address
you specified as the
Destination IP filter
setting will be ana-
lyzed.
– To analyze packets
sent to an address that
matches specific prefix
criteria, select Prefix,
and then specify the
length of the prefix that
you want the filter to
evaluate. Only packets
with prefixes that
match the prefix por-
tion of the destination
IP address (up to the
length that you speci-
fied) will pass through
the filter for analysis.
Setting Parameters
To Next Page
Loading...
