Chapter 4 IP Testing
Monitoring IP traffic
HST-3000 Ethernet Testing User’s Guide
161
6 If you need to specify other settings for the test, use the
left and right arrow keys to go to the appropriate menu;
otherwise, press the Home button to return to the Main
screen.
7 To start tracing the route, press the Action soft key, and
then select the Start Trace.
The HST-3000 traces the route. Results associated with
traceroute testing appear in the Traceroute results category
(see
“Traceroute results” on page 308).
Monitoring IP traffic
You can monitor and analyze 10/100/1G electrical or 1 G
optical layer 3 IP traffic by selecting the Monitor / Thru appli-
cation for the circuit you are testing.
To monitor IP traffic
1 Launch the Monitor / Thru application for the rate you are
testing (see “Launching an application” on page 28), and
select the Layer 3 IP Traffic test (see “Selecting a layer 3
IP test” on page 120).
2 Initialize the Ethernet link (see “Initializing the link for
Ethernet testing” on page 47.
3 Press the Configure navigation key, and then use the left
and right arrow keys to go to the Summary Settings or
Test Mode menu.
4 Select the Monitor or Thru type (for an explanation of
each application for the rate you are testing, see “Test
applications” on page 10 through page 15).
If you select the Thru type, you can specify Ethernet and
IP filter criteria for Port 1 and Port 2.
5 If you want to filter the traffic, specify the filter criteria on
the Ethernet Filter menu (see
“Filtering received traffic
using layer 2 criteria” on page 142) and the IP Filter menu
To Next Page
Loading...
