Chapter 6 Multiple Streams Testing
Configuring traffic streams
HST-3000 Ethernet Testing User’s Guide
187
Configuring traffic streams
After you specify the traffic characteristics that apply to all
streams, enable each of the traffic streams you want to
transmit, and specify the traffic loads, you specify the layer 2,
layer 3, and layer 4 characteristics for each stream (as appro-
priate). For example
– If you are transmitting layer 2 streams, you simply specify
the layer 2 settings for each stream.
– If you are transmitting layer 3 streams, you specify layer 2
and layer 3 characteristics.
– If you are transmitting layer 4 streams, you specify
layer 2, layer 3, and layer 4 characteristics.
To configure traffic streams
1 If you haven’t already done so, launch the IPv4 Multiple
Stream Terminate application for the circuit you are
testing (see “Launching an application” on page 28), and
then select your test (see “Selecting a multiple streams
test” on page 182).
2 Specify the settings that will apply to every enabled
stream, enable the streams you want to transmit, and
configure the traffic loads (see “Enabling streams and
specifying the traffic load” on page 183).
To Next Page
Loading...
