Chapter 6 Multiple Streams Testing
Enabling streams and specifying the traffic load
186
HST-3000 Ethernet Testing User’s Guide
If you are transmitting layer 4 streams, select DHCP or
Static IP - Single. The same address will be used for
all enabled streams.
c If you selected Static IP - Single, in Source IP, enter
the address that will be used by all enabled streams.
If you selected Static IP - Per Stream, you will specify
each stream’s IP address on the IP Config per Stream
configuration menu.
6 For each stream you want to enable, do the following:
a Use the up and down arrow keys to highlight the
stream, and then press OK.
b Select Constant or Ramped.
c If you selected a constant load, specify the load as a
percentage or a bit rate. If you indicate that you want
to transmit a constant load for every enabled stream,
you can optionally use the Distribute soft key to auto-
matically distribute the load evenly across the
streams.For a detailed discussion of constant traffic
loads, refer to “Transmitting a constant load” on
page 57.
If you selected a ramped load, specify the starting load
(for example,.50 percent or 10 Mbps), and then specify
the ramp step.For a detailed discussion of ramped
traffic loads, refer to “Transmitting a ramped load” on
page 61.
The traffic streams are enabled, and the traffic loads are spec-
ified. Proceed to “Configuring traffic streams”.
To Next Page
Loading...
