Chapter 6 Multiple Streams Testing
Enabling streams and specifying the traffic load
HST-3000 Ethernet Testing User’s Guide
185
5 If you are transmitting layer 3 or layer 4 streams, do the
following:
a Use the left and right arrows to go to the IP Init config-
uration menu.
b If you are transmitting layer 3 streams, in Source Type,
indicate whether you want to use DHCP to assign a
source IP address to be used by all enabled streams,
assign a Static IP -Single to be used by all enabled
streams, or a Static IP - Per Stream to specify a
different IP address for each stream.
Source MAC
(If Source MAC Mode
is Single)
– If you want to use the factory
assigned MAC address as
the source address for trans-
mitted streams, select
Factory Default.
– If you want to specify the
source MAC address to be
carried in transmitted
streams, select
User Defined, then type the
address in the Source MAC
fields.
NOTE: If you indicated that you
want to assign MAC addresses
on a per stream basis, you must
specify the addresses on the
Eth Config per Stream configu-
ration menu.
Load Unit Indicate whether you intend to
specify the bandwidth for each
stream as a Percent of the line
rate, or as a Bit Rate (in Mbps).
Fill Pattern Specify the pattern that will pop-
ulate the ATP payload for the
transmitted streams.
Settings Parameters
To Next Page
Loading...
