Chapter 6 Multiple Streams Testing
Enabling streams and specifying the traffic load
184
HST-3000 Ethernet Testing User’s Guide
3 Press the Settings soft key, and then select the All
Streams menu.
4 Specify the following settings. These settings will apply to
every enabled stream:
Figure 36 All Streams menu
Settings Parameters
Source MAC Mode
(Layer 2 Streams only)
– If you want to assign a single
source MAC address to be
used by all enabled streams,
select Single.
– If you want to assign a differ-
ent address for each stream,
select Per Stream.
NOTE: If you are running a
layer 3 streams test, the Source
Type is specified on the IP Init
configuration menu.
To Next Page
Loading...
