Chapter 1 Getting Started
Test scenarios
16
HST-3000 Ethernet Testing User’s Guide
Test scenarios
The following scenarios describe the various tests you might
perform using the HST. Your test requirements may vary;
these scenarios are intended to provide an overview of typical
test sessions. For step-by-step procedures for each of the key
applications, see:
– Chapter 3 “Ethernet Testing” (for layer 2 applications)
– Chapter 4 “IP Testing” (for layer 3 applications)
– Chapter 5 “TCP/UDP Testing” (for layer 4 applications)
Before testing, we strongly recommend that you read “Config-
uring your test” on page 25 to become comfortable with the
new interface. For detailed test result descriptions, see
Appendix A.
Verifying
connectivity
and evaluating
latency
In this scenario, you configure the HST to emulate service
from customer equipment on the link, and then verify connec-
tivity and evaluate latency on the circuit.
To Next Page
Loading...
