Chapter 1 Getting Started
Using J-Connect to discover another JDSU test set
HST-3000 Ethernet Testing User’s Guide
21
See
Figure 14.
After connecting to the circuit, you monitor traffic by observing
link statistics, counts, and errors for a specific MAC or IP
address, or Port number, or for a particular VLAN ID,
SVLAN ID, CVLAN ID, or MPLS label.
Using J-Connect to discover another JDSU test set
Before you begin testing, you can automatically detect other
JDSU test instruments on the same subnet and determine
their capabilities.You can then optionally configure key param-
eters for your test automatically based on a discovered instru-
ment’s settings.
Figure 14 Monitoring traffic using a dual port THRU
application
Service Provider’s Network
CPE
R/T 2R/T 1
HST-3000
To Next Page
Loading...
