Chapter 4 IP Testing
Initializing the link for IPoE testing
124
HST-3000 Ethernet Testing User’s Guide
5 If you need to specify other settings for the test, use the
left and right arrow keys to go to the appropriate configu-
ration menu; otherwise, press the Home button, and then
do the following:
– If you are initializing a 1G or 100M optical Ethernet
link, press the Action soft key, and then select
Laser On.
– Verify that the Sync LED is green (indicating that the
link is active).
– Display the IP Config results category to observe test
results associated with the IP connection.
The connection is established.
Establishing an
IPoE
connection for
IPv6 traffic
In addition to the settings you specify to establish an Ethernet
link, when establishing an IPoE connection that will carry IPv6
traffic, you also specify settings that indicate whether you
want to:
Source Type – DHCP - allows the unit to
obtain an IP address from a
DHCP server.
– Static - allows you to manu-
ally specify the IP, subnet,
and gateway addresses.
Source IP If the Source Type is Static,
enter the source IP address car-
ried by all traffic generated by
your unit.
Subnet Mask If the source IP type is Static,
enter the subnet mask.
Default Gateway If the source IP type is Static,
enter the default gateway
address.
Setting Parameters
To Next Page
Loading...
