Chapter 4 IP Testing
Initializing the link for IPoE testing
HST-3000 Ethernet Testing User’s Guide
123
4 Do the following:
a Use the left and right arrow keys to go to the IP Init
menu (see
Figure 25).
b Specify the following IP initialization settings:
Figure 25 IP Init configuration menu
Setting Parameters
ARP Mode – Enable - Enable ARP mode
if you want the HST to issue
an ARP request to automati-
cally determine the MAC
address of its link partner. In
most instances ARP should
be enabled.
– Disable - If you disable ARP
Mode, be certain to specify
the Destination MAC
address for the HST’s link
partner (on the Ethernet
menu).
To Next Page
Loading...
