Chapter 1 Getting Started
Using J-Connect to discover another JDSU test set
24
HST-3000 Ethernet Testing User’s Guide
If the instrument does not discover any other test instruments,
a message appears stating that no devices were discovered.
About the
Refresh soft
key
The Refresh soft key appears whenever the Discovered
Devices screen is displayed. Use the button to rediscover
devices on the subnet (for example, if you suspect a discov-
ered device is no longer connected to the circuit).
Sorting
discovered
instruments
By default, discovered instruments are listed by their unit iden-
tifiers. You can optionally sort them by serial number, applica-
tion name, MAC, or IP address.
To sort discovered instruments
1 Discover the instruments.
2 On the Discovered Devices screen, press the
Display By ...soft key.
3 Select the sort key.
The instruments are sorted using the new key.
Observing
details for an
instrument
After discovering the instruments, you can observe details for
a particular instrument, and indicate whether or not you want
to use the discovered instrument’s MAC and IP address when
you configure your instrument.
NOTE:
You can also discover other instruments when you specify
destination addresses for transmitted traffic, and source
addresses carried in filtered traffic. For details, refer to
“Configuring layer 2 Ethernet tests” on page 51, “Configur-
ing layer 3 IP tests” on page 136, or “Configuring layer 4
traffic” on page 167.
To Next Page
Loading...
