Chapter 5 TCP/UDP Testing
Configuring layer 4 traffic
HST-3000 Ethernet Testing User’s Guide
169
Specifying the
traffic mode
and ports
If you selected the Layer 4 Traffic test, before you transmit
traffic you must indicate whether the traffic will carry a TCP or
UDP header, and specify the source and destination port
numbers for the generated traffic.
Port 0 (zero) is reserved by TCP/UDP for networking; there-
fore, it is not available when you configure your traffic.
NetMeeting T.120 1503
NetMeeting User Location Service 522
NetMeeting User Location
Service ULS
522
NNTP 119
NNTP (SSL) 563
Radius accounting (Routing and
Remote Access)
1646 or
1813
Radius authentication (Routing and
Remote Access)
1645 or
1812
Remote Install TFTP 69
SNMP 161
SNMP Trap 162
Telnet 23
WINS NetBios over TCP/IP name
service
137
WINS Proxy 137
WINS Registration 137
WINS Replication 42
Table 12 Well Known TCP/UDP Ports (Continued)
Service Name TCP Port UDP Port
To Next Page
Loading...
