Chapter 5 TCP/UDP Testing
Configuring layer 4 traffic
170
HST-3000 Ethernet Testing User’s Guide
The following port numbers are also reserved, and can not be
used during loopback testing. They can be specified when
testing end-to-end.
– 111
– 1022
– 1023
To specify packet characteristics for transmitted traffic
1 If you haven’t already done so, launch the IPv4 or IPv6
Terminate application for the circuit you are testing (see
“Launching an application” on page 28), and then select
the Layer 4 Traffic test (see “Selecting a layer 4 TCP/UDP
test” on page 165).
2 Press the Configure navigation key.
A configuration menu appears.
3 Do the following:
a Use the left and right arrow keys to go to the TCP/UDP
menu (see Figure 34).
Figure 34 TCP/UDP configuration menu
To Next Page
Loading...
