Chapter 5 TCP/UDP Testing
Configuring layer 4 traffic
HST-3000 Ethernet Testing User’s Guide
171
b Specify values for the following settings:
Setting Parameters
Traffic Mode Indicate whether you want to
transmit traffic with a TCP or
UDP header.
ATP Listen IP Type Select one of the following:
– Auto Obtained
– User Defined
ATP Listen IP
(ATP Listen IP Type
must be User Defined)
If you want to analyze traffic
with an ATP payload, and you
indicated that you want to spec-
ify a specify a user defined
address, specify the IP address
carried in the received ATP traf-
fic.
NOTES:
– If your unit has been looped
up by another HST, the ATP
Listen IP will automatically
be populated for you.
– You can optionally use the
Discover soft key to dis-
cover other instruments on
the network, and then select
the source address for the
device you want to filter traf-
fic for. For details, see
“Using J-Connect to dis-
cover another JDSU test
set” on page 21.
To Next Page
Loading...
