Chapter 5 TCP/UDP Testing
Configuring layer 4 traffic
172
HST-3000 Ethernet Testing User’s Guide
ATP Listen Port If you want to analyze traffic
with an ATP payload, specify
the port designated for ATP traf-
fic. The default listen port is
10004.
NOTES:
– If your unit has been looped
up by another HST, the ATP
Listen Port will automatically
be populated for you.
– You can optionally use the
Discover soft key to dis-
cover other instruments on
the circuit, and then select
the source port for the
device you want to filter traf-
fic for. For details, see
“Using J-Connect to dis-
cover another JDSU test
set” on page 21.
Source Port
a
Enter the source port number
carried by all traffic generated
by your unit.
Destination Port Enter the destination port num-
ber carried by all traffic gener-
ated by your unit.
NOTE: You can optionally use
the Discover soft key to dis-
cover other instruments on the
circuit, and then select the des-
tination port for the device you
want to transmit traffic to. For
details, see “Using J-Connect to
discover another JDSU test set”
on page 21.
Setting Parameters
To Next Page
Loading...
