Chapter 6 Multiple Streams Testing
Transmitting multiple streams
HST-3000 Ethernet Testing User’s Guide
191
To copy a traffic stream’s settings
1 If you haven’t already done so, launch the IPv4 Multiple
Stream Terminate application for the circuit you are
testing (see “Launching an application” on page 28), and
then select your test (see “Selecting a multiple streams
test” on page 182).
2 Specify the settings that will apply to every enabled
stream, enable the streams you want to transmit, and
configure the traffic loads (see “Enabling streams and
specifying the traffic load” on page 183).
3 Configure the first traffic stream (see “Configuring traffic
streams” on page 187).
4 On the Eth Config per Stream, IP Config per Stream, or
L4 Config per Stream configuration menu, select Copy
All Settings.
A message will appear asking if you want to copy the
settings to every other enabled stream.
5 Select OK.
The HST copies the settings to every traffic stream.
Transmitting multiple streams
After you enable and configure traffic streams, you are ready
to transmit the streams over the link.
1 If you haven’t already done so, launch the IPv4 Multiple
Stream Terminate application for the circuit you are
testing (see “Launching an application” on page 28), and
then select your test (see “Selecting a multiple streams
test” on page 182).
2 Press the Configure navigation key.
A configuration menu appears.
To Next Page
Loading...
