Chapter 4 IP Testing
Configuring layer 3 IP tests
HST-3000 Ethernet Testing User’s Guide
147
4 If you need to specify other settings for the test, use the
left and right arrow keys to go to the appropriate configu-
ration menu; otherwise, press the Home key to return to
the Summary Results screen.
The unit is configured to analyze received traffic satisfying the
layer 3 IPv4 filter criteria.
Address Filter – To analyze traffic coming
from a single direction on
the circuit, select
Single Direction.
– To analyze traffic from
either direction on the cir-
cuit, select
Either Direction. Pack-
ets with either a source
address or destination
address that matches the
address you specified as
the Source IP filter will be
analyzed.
TOS/DSCP
(if IP Filter is enabled)
Select one of the following:
– To analyze received pack-
ets for any type of service
or DSCP, select Don’t
Care.
– To analyze packets for a
specific type of service,
select Type of Service,
and then specify the TOS
using a binary format.
– To analyze packets for a
specific DSCP, select
DSCP, and then select a
name.
Setting Parameters
To Next Page
Loading...
