Chapter 3 Ethernet Testing
MAC-in-MAC testing
112
HST-3000 Ethernet Testing User’s Guide
Encapsulation – To analyze frames
that are not tagged,
select None.
– To analyze VLAN
tagged frames, select
VLAN, and then spec-
ify the VLAN Tag and
User Priority for the
tagged frames.
– To analyze Q-in-Q
tagged frames, select
Q-in-Q, and then
specify the CVLAN
Tag and User Priority,
and the SVLAN set-
tings for the tagged
frames.
– If you do not want to
filter frames based on
their tagged status,
select Don’t Care.
Payload Analysis – To analyze traffic with
a BERT or Acterna
payload, select On.
– If you do not want to
analyze traffic based
on the type of payload
(you want the unit to
monitor live traffic),
select Off
Rx = Tx
(if Payload on Ethernet -Cus-
tomer Frame configuration
menu is BERT)
– To analyze frames
with the same pay-
load specified for
transmitted frames,
select Yes.
– If you want to analyze
frames with a different
payload, select No.
Setting Parameters
To Next Page
Loading...
