Chapter 3 Ethernet Testing
MAC-in-MAC testing
HST-3000 Ethernet Testing User’s Guide
111
the right arrow to go to the Filter - Customer Frame
configuration menu, and then specify the following:
I-Tag Service ID Enter the service ID car-
ried in the filtered traffic,
or use the Don’t Care but-
ton to analyze all traffic
irrespective of the ID.
Setting Parameters
Destination Type To analyze frames for a
specific type of destination
address, select one of the
following:
– Unicast
– Multicast
– Broadcast
If you do not want to filter
frames based on the des-
tination address type,
select Don’t Care.
Destination MAC To analyze frames sent to
a specific Unicast or Multi-
cast address, enter the
destination address.
Source Type – To analyze frames
sent from a specific
address, select
Unicast.
– If you do not want to
filter frames sent from
a specific address,
select Don’t Care.
Source MAC
(if Source Type is Unicast)
To analyze frames sent
from a specific address,
enter the source address.
Setting Parameters
To Next Page
Loading...
