Chapter 6 Multiple Streams Testing
Configuring traffic streams
HST-3000 Ethernet Testing User’s Guide
189
4 If you are transmitting layer 3 or layer 4 streams, use the
right arrow key to go to the IP Config per Stream menu,
and then specify the layer 3 characteristics for each
stream.
If you are running a layer 3 test, and you indicated that
you want to specify a different source IP address for each
stream, be certain to enter the Source IP for each stream.
For an explanation of each of the settings, see
step 3 on
page 138 of “Specifying IP packet settings”.
To Next Page
Loading...
