JDS Uniphase HST-3000 - Page 160

Chapter 4 IP Testing
Configuring layer 3 IP tests
138 HST-3000 Ethernet Testing User’s Guide
– If you indicated that you want to specify a frame length for
transmitted traffic, you must specify the length on the
Ethernet configuration menu.
To specify packet characteristics for transmitted traffic
1 If you haven’t already done so, launch your IPv4 or IPv6
application (see “Launching an application” on page 28),
and then select a test (see the appropriate procedure
below):
– “Selecting a layer 3 IP test” on page 120
– “Selecting a layer 4 TCP/UDP test” on page 165
– “Selecting a multiple streams test” on page 182
2 Press the Configure navigation key.
A configuration menu appears.
3 Do the following:
a Use the left and right arrow keys to go to the IP menu
(see Figure 29).
Figure 29 IP configuration menu (IPv4 settings)