Chapter 4 IP Testing
Configuring layer 3 IP tests
HST-3000 Ethernet Testing User’s Guide
139
b Specify values for the following settings:
IPv4 IPv6 Setting Parameters
Yes Yes Destination IP Enter the destination IP
address for traffic gener-
ated by your unit.
NOTE: You can optionally
use the Discover soft key to
discover other instruments
on the circuit, and then
select the destination
address for the device you
want to transmit traffic to.
For details, see “Using J-
Connect to discover
another JDSU test set” on
page 21.
Yes No Time To Live Specify the time after which
a packet can be deleted by
any device on a circuit as a
number of hops. The default
time to live setting is 64
hops.
Yes No TOS/DSCP Enter a number represent-
ing the type of service in a
binary format, or select a
DSCP name.
No Yes Traffic Class Enter a number represent-
ing the traffic class using a
hexadecimal format rang-
ing from 0x0 to 0xFF.
Yes No Protocol Enter a number represent-
ing the protocol using a
hexadecimal format rang-
ing from 0x0 to 0xFF.
Yes Yes Tx Payload Select one of the following:
– Acterna
– Fill Byte
To Next Page
Loading...
