Chapter 4 IP Testing
Configuring layer 3 IP tests
140
HST-3000 Ethernet Testing User’s Guide
Yes Yes Acterna Payload If you are transmitting an
Acterna Tx Payload, select
one of the following:
– BERT
– Fill Pattern
Yes Yes Pattern If you are transmitting a
BERT pattern in the ATP
payload, select one of the
following:
– A predefined PRBS or
fixed pattern.
– User Defined, and then
enter the pattern in
hexadecimal format
Yes Yes Fill Byte If you are transmitting a Fill
Byte payload, enter the fill
byte in hexadecimal format
ranging from 0x0 to 0xFF.
Yes Yes Fill Pattern If you are transmitting a Fill
Pattern in an ATP payload,
specify the pattern in a
hexadecimal format up to
64 bytes long.
Yes Yes Packet Length
(if Length Select setting on
the Test Mode menu is
Packet Length)
– A predefined length.
– Random, which sends
packets with randomly
generated, predefined
RFC 2544 traffic
lengths.
– User Defined, and then
specify the packet
length.
– Jumbo, and then specify
the packet length.
IPv4 IPv6 Setting Parameters
To Next Page
Loading...
