JDS Uniphase HST-3000 - Page 55

Chapter 1 Getting Started
Configuring your test
HST-3000 Ethernet Testing User’s Guide
33
RFC 2544 Mode Select one of the follow-
ing:
– Disable. Select Dis-
able if you do not
intend to run
RFC 2544 tests while
running the current
application.
– Symmetric. Select
Symmetric if you
intend to run the stan-
dard symmetric test
because the uplink
and downlink speeds
on the circuit you are
testing are the same.
– Asym Upstream.
Select Asym
Upstream if you intend
to run the asymmetric
test upstream only.
– Asym Downstream.
Select this if you
intend to run the
asymmetric test down-
stream only.
– Asym Combined.
Select this if you
intend to run the
asymmetrical test in
both directions
(upstream and down-
stream).
For details, see
Chapter 7 “Automated
RFC 2544 Testing”.
Setting Parameters