Chapter 1 Getting Started
Configuring your test
32
HST-3000 Ethernet Testing User’s Guide
To specify test mode and network visibility settings
1 Launch an application (see “Launching an application” on
page 28).
The HST launches the application, and the Summary
Results screen appears.
2 Press the Configure navigation key, then use the right
arrow key to display the Test Mode menu and specify the
following:
Setting Parameters
Test Use this setting to select
the test for the application
that you launched.
Res. Precision Select 3, or 4.
Result Unit Select one of the follow-
ing:
– Mbps
– Kbps
– Auto. Select Auto to
automatically deter-
mine the result unit. If
the measurement is
less than or equal to 1
Mbps, the result is pre-
sented in Kbps. If the
result is higher than 1
Mbps, the result is pre-
sented in Mbps.
To Next Page
Loading...
