Chapter 4 IP Testing
Configuring layer 3 IP tests
144
HST-3000 Ethernet Testing User’s Guide
b Specify values for the following settings:
Setting Parameters
IP Filter Select one of the following:
– If you want to filter
received traffic using layer
3 criteria, select Enable.
You must enable the IP
Filter if you want to ana-
lyze only layer 3 IP traffic.
– If you do not want to filter
received traffic using layer
3 criteria, select Disable.
Specify Source
(if IP Filter is enabled)
Select one of the following:
– To analyze received pack-
ets from any IP address,
select Don’t Care.
– To analyze packets sent
from a specific IP address,
select Yes.
Source IP
(if Source Address IP is
Yes)
Enter the source address for
filtered packets.
NOTE: You can optionally use
the Discover soft key to dis-
cover other instruments on
the circuit, and then select the
source address for the device
you want to filter traffic for. For
details, see “Using J-Connect
to discover another JDSU test
set” on page 21.
To Next Page
Loading...
