JDS Uniphase HST-3000 - Configuring layer 4 traffic

Chapter 4 IP Testing
Configuring layer 3 IP tests
HST-3000 Ethernet Testing User’s Guide
145
Source Subnet
(if Specify Source is
Yes)
Select one of the following:
– To analyze received pack-
ets for a specific source IP
address, select None.
Packets with a source
address that matches the
address you specified as
the Source IP filter setting
will be analyzed.
– To analyze packets that
match specific prefix crite-
ria, select Prefix, and then
specify the length of the
prefix that you want the fil-
ter to evaluate. Only pack-
ets that match the prefix
portion of the source IP
address (up to the length
that you specified) will
pass through the filter for
analysis.
– To analyze packets that
match specific subnet
address criteria, select
Mask, and then specify
the subnet address for the
traffic that you want to
evaluate. Only packets
that carry the address will
pass through the filter for
analysis.
Specify Dest
(if IP Filter is enabled)
Select one of the following:
– To analyze received pack-
ets sent to any IP address,
select Don’t Care.
– To analyze packets sent
to a specific IP address,
select Yes.
Setting Parameters