JDS Uniphase HST-3000 - Page 233

Chapter 7 Automated RFC 2544 Testing
Running the Classic RFC 2544 test
HST-3000 Ethernet Testing User’s Guide
211
4 Do one of the following:
– If a configuration exists with the settings (or the
majority of the settings) that you need to run the test,
select the configuration from the menu. The
Run or Edit Configuration As dialog box appears.
– To run the test without modifying the configuration
settings, select RUN. Proceed to
step 9 on page 213.
– To create a new configuration using the selected
configuration as a template, type a name for the new
configuration, and then select OK. The HST Setup
dialog box appears, listing key parameters specified
for the test. Proceed to step 5 on page 211.
– If you want to create a new configuration, select New
Configuration. The New Configuration Name dialog
box appears. Type a name for the new configuration,
and then select OK. The HST Setup dialog box
appears, listing key default parameters specified for
the test. Proceed to step 5 on page 211.
5 Do one of the following:
– If the parameters on the HST Setup dialog box are
acceptable, select OK, and then proceed to step 6 on
page 212.
– If you need to change any of the parameters displayed
on the HST Setup dialog box, select Change. The
Choose Test Type menu appears. Select one of the
following:
Layer 2 Traffic - to run the script in layer 2 test mode.
Layer 3 IP Traffic - to run the script in layer 3 test
mode.
Layer 4 Traffic - to run the script in layer 4 test mode.
Proceed to step 6 on page 212.