Appendix A Test Results
IP Config results
296
HST-3000 Ethernet Testing User’s Guide
PPPoE Status Displays one of the following messages
that indicate the current status of the
PPPoE session:
– INACTIVE
– PPPOE ACTIVE
– PPP ACTIVE
– PPPOE UP
– USER REQUESTED INACTIVE
– PPPOE TIMEOUT
– PPPOE FAILED
– PPP LCP FAILED
– PPP AUTHENTICATION FAILED
– PPP IPCP FAILED
– PPP UP FAILED
– INVALID CONFIG
Preferred Life
Time(s)
Displays the duration (in seconds) that
addresses assigned via stateless auto-
configuration using the prefix remain
preferred.
Remote IP Addr. Displays the IP address of the PPPoE
partner. If your HST is operating as a
server, the IP address of the client
appears. If your HST is operating as the
client, the IP address of the server
appears.
Source IP Addr. In IPoE mode, displays the IP address
for the currently configured port.
Subnet Prefix
Length
Displays the subnet prefix length used
to generate the required IPv6 global
address for the HST.
Valid Life Time(s) Displays the duration (in seconds) that
addresses generated from the prefix
are considered valid when establishing
a link.
Table 34 IP Config test results (Continued)
Result Description
To Next Page
Loading...
