JDS Uniphase HST-3000 - Page 48

Chapter 1 Getting Started
Configuring your test
26 HST-3000 Ethernet Testing User’s Guide
– You must select a Terminate or Multi-Stream Terminate to
run Layer 4 tests.
– Certain softkeys, applications, and tests only appear if
you purchased and loaded the associated software
options.
Table 9 Supported Applications, Test Modes, and Traffic
Soft key / Circuit Application Test/Traffic
ETH ELEC
10/100/1G electrical
Terminate – Layer 2 Traffic
– Layer 2 Transparency
– Layer 3 IP Traffic
– Layer 3 PING
– Layer 3 Traceroute
– Layer 4 Traffic
Multi-Stream Terminate – Layer 2 Streams
– Layer 3 Streams
– Layer 4 Streams
Monitor / Thru – Layer 2 Traffic
– Layer 3 IP Traffic
MAC-in-MAC Terminate MAC-in-MAC
(selected automatically)
MAC-in-MAC Monitor / Thru MAC-in-MAC
(selected automatically)
Cable Diagnostics Cable Diagnostics
(selected automatically)