Chapter 3 Ethernet Testing
Configuring layer 2 Ethernet tests
60
HST-3000 Ethernet Testing User’s Guide
4 Specify values for the following settings:
Setting Parameters
Load Type Burst
Burst Load Unit – Interval
– Percent
Duty Cycle (%)
(if Burst Load Unit is Percent)
Enter the load to transmit
during bursts as a per-
centage of the line rate.
Time Unit
(if Burst Load Unit is Interval)
Select the unit of time for
the burst and gap/idle
times you will specify:
– sec
– msec
– usec
– nsec
Burst Time
(if Burst Load Unit is Interval)
Enter the time to transmit
each burst of traffic.
Gap/Idle Time
(if Burst Load Unit is Interval)
Enter the time between
each burst of traffic. The
valid range for this setting
adjusts depending on the
Burst Time that you
entered, to ensure that the
duty cycle is at least
0.001%.
To Next Page
Loading...
