Chapter 3 Ethernet Testing
Using J-Proof to verify layer 2 transparency
HST-3000 Ethernet Testing User’s Guide
77
5 Enable the transparency frames that you want to transmit
by doing the following:
a Press the Home button to return to the Summary
Results screen.
b Use the right arrow key to go to the J-Proof Frame List
configuration menu.
c Scroll to and highlight the transparency frame that you
want to enable using the up and down arrow keys.
Destination Type To transmit frames to a
specific type of destination
address, select one of the
following:
– Unicast
– Multicast
– Broadcast
Most protocols only allow
you to send traffic to a
multicast address; how-
ever, if you specified a
user-defined protocol, you
can select a Unicast or
Broadcast address type.
Destination MAC
(if Destination Type is Unicast
or Multicast)
To transmit frames to a
specific Unicast or Multi-
cast address, enter the
destination address.
EtherType
(DIX frames only)
Type the protocol ID for
the data in the frames
using a 2 byte hexadeci-
mal format.
LLC
(802.3 frames only)
Displays the DSAP, SSAP,
and CTL values for the
protocol that you speci-
fied.
Setting Parameters
To Next Page
Loading...
