JLG X20JPLUS - Page 188

186
BoomLiftModels X20JPLUS
SAFETYSTANDARDSFORTRANSPORT
MUX20JP021602
•Widenthecarriageplatformbeforetacklingtheramps.
•Adjustthedistancebetweentherampsinfunctionoftheroadwayofthetwo
tracks.
• Alwaysemptythebasketbeforetacklingtheramps.
• Climb the ramps proceeding with the machine oriented with the basket
towardstherear.
• Closetothevariationofinclinationbetweenrampandfl
oortruck/trailer,
proceedwithgreatcautiontoavoidjolts.
• Proceedveryslowlyontherampsadjustin gthespeedwiththeproportional
levers.Intheelevation changesproceedatminimumspeed  possible.MAKE
SURETHATTHEENGINEISATIDLESPEED(turtlespeed select).Maintain
aconstantspeed.Avoidabruptstartsandbraki
ng.Makesurebeforeprocee‐
dingontherampsthateachtrackisFULLYcontentonthesurfaceofeachramp.
In tackling the ramps proceed with PERFECTLY straight trajectory making
sureatALLtimes thateach track is FULLY contained onthesurfaceof each
ramp.
•Placethemachinesothatnopartofitco
mesoutoftheshapeofthevehicle.
Forthedescentfollowtherequirementsabove.
Duringthetranslationphasesandstagesofchangeofslopecarefulnottoda‐
magethesafetydevices placedunderthebasketandneartheendofthefirst
extension.Inthecaseofthechangeofslopewouldbetoohi
ghchangetheslo‐
peoframpsoruserampslonger.