JLG X20JPLUS - Remote Control MOVE (Optional)

INSTRUMENTSANDCONTROLS
69
MUX20JP021602
BoomLiftModels X20JPLUS
9.4. REMOTECONTROLMOVE(OPTIONAL)
Inordertoenablethegroundmovementsofthemachineiscompulsorypushthe
8button.Ifthe8buttonisnotpressedbeforemovethegroundpartamessage
appear on the remote control display. Once pressed the 8 key if are not move
commandswithin7secon
dsconsentswillbedisabledandwillbeneedtopress
thebutton8againtoreacti vatethem.
9.5. SKYGUARD
TM
SYSTEM(OPTIONAL)
TheSkyGuard
TM
featureisusedtoprovideenhancedcontrolpanelprotection.
WhentheSkyGuard
TM
sensorisactivated,functionsthatwereinuseatthetime
ofactuationwillreverseorcut‐outandthegroundalarmwillbeep.Thetablebe‐
lowoutlinesthesefunctions.
IfSkyGuard
TM
remainsactivatedafterfunctionreversalorcutout,depressand
holdtheSkyGuard
TM
OverrideSwitch(buttonnumber8)toallownormaluseof
machinefunctionsuntiltheSkyGuard
TM
sensorisdisengaged.
ThisoptionisenabledasstandardfortheAustralianmarketmachine.
Reversemotioncanbestoppedbytheoperatorbyreleasingthefootswitch,depres‐
singtheemergencystopbutton,orbyreleasingpressureontheSkyGuard
TM
sen‐
sor.
1boom
up
3boom
up
JIBup Exten‐
sion
out
Rota‐
tion
AE
Rota‐
tion
Basket
Basket
level‐
ling
Drive
Forwar
d
Drive
Rever‐
se
RRCRRCCCC
R=IndicatesReversalisActivated
C=IndicatesCutoutisActivated