Установка грузов за спицами
Behind-the-spokes placement
8.4.2 Установка балансировочных грузов
Установка клеевых грузов на левой
стороне диска
• .
•
8.2.2.
Установка скрытых клеевых грузов
(Рис. 8-21).
•
(
) (A, Рис. 8-22)
.
• .
• (
55 A, Рис. 8-22) .
•
.
• ,
(
75 , B, Рис. 8-22).
Примечание:
,
.
8.4.2 Weights placement
How to fit adhesive weights on the left side of
the rim disc
• Clean the fitting position before attaching the
adhesive weights.
• Fit adhesive weights on the left side of the rim disc
as described in 8.2.2.
Applying hidden adhesive weights
The measured values and the positioning arrows for the
two correction positions behind the spokes (Figure 8-
21) are given on the right of the Indications Field.
• Turn the wheel to move one of the split imbalances,
on the right side ( A,Figure 8-22) into the
compensation position (green arrows), then lock the
wheel with the brake pedal.
• Clean the application point before attaching the
adhesive weight.
• Apply the balance weight (in the example 55 grams,
A,Figure 8-22) at the point indicated.
• Turn the wheel to reach the remaining split right
side weights compensation position, then lock the
wheel with the brake pedal.
• Having cleaned the area affected, apply behind the
second spoke the weight of the value indicated (in
the example 75 grams, B,Figure 8-22).
Note:
Applying split weights does not involve priorities.The
operator can choose which to apply first.
To Next Page
Loading...