6.3 Подготовка к калибровке
p
.
•
(Рис. 6-7) .
• .
.
6.4 Цикл компенсации
.
( 6.
).
.
•
.
.
• (Рис. 6-8) F6
(1, Рис. 6-8).
• START.
.
.
F6 (1, Рис. 6-8a)
, .
6.3 Preparing for calibration
For readjustment of a p balancer the clamping device must
be clamped without wheel.
Fit the small centring cone, the middle centring
cone and the clamping sleeve without clamping
head (Fig. 6-7) on the chuck.
Start the clamping process.
The device should be calibrated exactly as described in
the relevant chapters.
6.4 Compensation Run
All clamping and centring means are balanced in our
works to within a certain tolerance.
To compensate for any residual unbalance that might be
left in the clamping means, it is recommended that an
electrical compensation run be performed after switching
on the machine or after changing the wheel adaptor,
especially a motorcycle wheel adaptor (also se 6.
Changing modes of operation). This mode cannot be
transferred into the permanent memory.
Fit the clamping device properly on the balancer
shaft. Do not fit the wheel.
Starting from the screen main menu (Fig. 6-8) press
the menu key F6 for electrical compensation of
unbalance in clamping means (1, Fig. 6-8).
Start the compensation run with the START key.
The compensation run takes longer than a regular
measuring run. After the Compensation Run, an icon in
the status Bar indicates the Compensation Active status.
This mode of operation is retained until deleted by
pressing menu key F6 (1, Fig. 6-8a) again, by starting
readjustment or an optimisation run, or by switching off
the machine.
To Next Page
Loading...