− 5 −
3-2 Assembling the pedal section of the stand
7
2
3
8
8
4
5
2
7
1
6
1
1) Assemble the lower strut to the stand using square nut 7(wide width).
2) Put bush 4 to the pedal 8 and pass it through shaft 5 together with shaft bearing plate 3. Then fix with
pedal shaft bearing 2.
3) Fix pedal shaft bearing 2 using square nut 1 (narrow width).
4) Assemble the whole pedal after fully drawing it up in the left direction in the illustration.
[When using with 1-pedal]
There is the short shaft for 1-pedal in the accessories. Remove the small pedal and shaft bearing plate 3
and replace the shaft with the shaft for 1-peadl. Then the machine can be used even with 1-pedal.
To Next Page
Loading...
