− 60 −
1
3
2
A
B
4
7-7 Creating the pattern <Pattern creation>
1) Prepare the materials.
2) Turn the power ON.
3) Call a sample pattern where the sewing product
and number of steps are the same.
Refer to "7-5 (3) Calling the pattern".
4) Change the pitch.
Refer to "7-6 (2) Changing the pitch".
5) Select left/right alternate sewing.
Refer to "7-5 (4) Selecting the left/right alternate
sewing".
6) Press READY key 1.
7) Start sewing.
8) Stop the sewing machine at each notch and
perform checking of shirring amount.
9) When notches do not correspond with each other,
press "+"/ "–" buttons 2 after thread
trimming on the way to change shirring amount
set value A, and perform re-sewing.
Refer to "7-6 (4) Changing the shirring amount".
10) When the sleeve material on the outlet seam side
delays, press "+"/ "–" buttons 3
after thread trimming on the way to change shirring
amount for auxiliary feed set value B, and perform
re-sewing.
Refer to "7-6 (5) Changing the shirring amount
of auxiliary feed".
11) When the program of one sleeve is completed,
sew the other sleeve and correct the program.
12) When the program is completed, press MEASURE
button 4.
13) Start sewing.
14) When sewing is performed up to the next notch,
stop the sewing machine once.
The way of correcting the sample pattern and creating the pattern with ease is explained in the basic volume.
To Next Page
Loading...
