JUKI DP2100 - Installation; Assembling the table

− 6 −
3-3 Assembling the table
1
2
3
4
5
5
7
6
7
6
8
!0
9
!1
9
!2
!3
8
1) Fix hinge seats 5 and machine head supporting rubbers 6 on table 1 with the nails. (Use 2 pcs. each
of nail for fixing hinge seats 5 and 1 pc. each of nail for fixing machine head supporting rubbers.)
2) Attach felts 7 to machine head supporting rubbers 6.
3) Attach machine head supporting rubbers 8 to table 1.
4) Fix stopper plate 9 to the rear side of table 1.
Caution) Be sure to install stopper plate 9 before installing control box 2.
5) Fix control box 2 and power switch 3, and fix the power cable with the staples.
6) Fix power switch 3 under the machine table witch wood screw !4. Fix the cable with staple !5 supplied
with the machine as accessories in accordance witch the forms of use.
7) Temporarily fix the side strut so that it is put between auxiliary pedal sensor !0 and sensor plate !1.
8) Connect pedal (large) and pedal sensor !2 with connecting rod (long). Adjust the inclination of connecting
rod at the position of adjusting plate !3.
9) Connect pedal (small) and auxiliary pedal sensor !0 with connecting rod (short). Adjust the inclination
of connecting rod at the position of auxiliary pedal sensor and securely tighten the screw.
10) Install head supporting rod 4 on table 1.
!4
!5