FX-3R Maintenance Guide
12-15
4) The folder named “machine” is then created under the D drive. In the same manner as
described above, create “prg” folder under the machine folder.
5) Click the created “Prg” folder with the right button, and select the [Sharing and Security] or
[Properties] command.
6) The “Prg Properties” dialog box appears on the screen. Click the “Sharing” tab from this
dialog box, and select the “Share this folder” radio button to check to see if “Prg” is entered
as the “Share Name.”
• If “Prg” is not entered in the “Shared Name” field, change the entered name to “Prg.”
• If any name is not entered, select the “Maximum Allowed” radio button for the “User Limit”
item.
*Note
Set up a shared folder so
that the shared folder name
“prg” is not duplicated in the
computer.
If a shared folder named
“prg” already exists, change
the name of the previously
existing folder name to that
other than “prg”.
Rev. 1.00
To Next Page
Loading...
Need help?
General
