Juniper ACX5048 - Page 105

Table 41: QSFP+ Active DAC Breakout Cable Specifications
SpecificationsProduct SKU
40-Gbps full-duplex serial transmissionRateJNP-QSFP-DACBO-5MA
None. SFPs are permanently attached.Connector type
3.3 VSupply voltage
–40
°
C to 85
°
CStorage temperature
TwinaxCable type
30 AWGWire AWG
0.3 in. (0.762 cm)Minimum cable bend radius
100 ohmsCable characteristic impedance
4.5 nec/mTime delay
5 m (16.4 ft)Length
40-Gbps full-duplex serial transmissionRateJNP-QSFP-DACBO-7MA
None. SFPs are permanently attached.Connector type
3.3 VSupply voltage
–40
°
C to 85
°
CStorage temperature
TwinaxCable type
30 AWGWire AWG
0.3 in. (0.762 cm))Minimum cable bend radius
100 ohmsCable characteristic impedance
4.5 nsec/mTime delay
7 m (22.9 ft)Length
Related
Documentation
Interface Specifications for SFP, SFP+, and QSFP+ Transceivers for an ACX5000
Router on page 62
•
• Interface Specifications for SFP+ DAC Cables for an ACX5000 Router on page 77
• Interface Specifications for QSFP+ DAC Cables for an ACX5000 Router on page 86
85Copyright © 2015, Juniper Networks, Inc.
Chapter 7: Port and Interface Specifications