Juniper ACX5048 - Removing a Power Supply from an ACX5000 Router

Figure 48: Installing Power Supply in an ACX5048
g000822
Figure 49: Installing Power Supply in an ACX5096
NOTE: Each power supply must be connected to a dedicated power source
outlet.
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp .
Failure to do so can result in significant delays if you need replacement parts.
This note does not apply if you replace components with the same type of
component.
Related
Documentation
AC Power Supply for an ACX5000 Router on page 37•
• DC Power Supply for an ACX5000 Router on page 39
• Connecting AC Power to an ACX5000 Router on page 114
• Connecting DC Power to an ACX5000 Router on page 116
• Removing a Power Supply from an ACX5000 Router on page 138
Removing a Power Supply from an ACX5000 Router
The power supplies in an ACX5000 router are hot-removable and hot-insertable
field-replaceable units (FRUs): you can remove and replace them without powering off
the router or disrupting routing functions.
Copyright © 2015, Juniper Networks, Inc.138
ACX5048 and ACX5096 Universal Access Router