Juniper ACX5048 - Interface Support for an ACX5000 Router

Table 29 on page 59 provides the pinout information of the RJ-45 management port
connector. An RJ-45 cable is supplied with an ACX5000 router.
Table 29: RJ-45 Management Port Connector Pinouts for an ACX5000 Router
DescriptionSignalPin
Transmit/receive data pair 1TRP1+1
Transmit/receive data pair 1TRP1–2
Transmit/receive data pair 2TRP2+3
Transmit/receive data pair 3TRP3+4
Transmit/receive data pair 3TRP3–5
Transmit/receive data pair 2TRP2–6
Transmit/receive data pair 4TRP4+7
Transmit/receive data pair 4TRP4–8
Related
Documentation
Management Port LEDs on an ACX5000 Router on page 24•
Interface Support for an ACX5000 Router
All the router models s of the ACX5000 router supply quad small form-factor pluggable
plus (QSFP+) ports for use as uplinks or as access ports. These 40 GbE ports support
QSFP+ transceivers, QSFP+ direct-attach copper (DAC) cables, and DAC breakout cables
(DACBO). The ACX5048 has 6 QSFP+ ports; the ACX5096 has 8 QSFP+ ports that can
all be used as uplinks.
On all ACX5000 routers, the ports are enabled by default.
Downlink ports are product SKU-specific:
•
ACX5096—has 96 SFP+ ports that support SFP and SFP+ transceivers, as well as DAC
cables.
•
ACX5048—has 48 SFP+ ports that support SFP and SFP+ transceivers, as well as DAC
cables.
Figure 27 on page 60 shows the location of SFP+ and QSFP+ ports for the ACX5096,
Figure 28 on page 60 shows these ports for the ACX5048.
59Copyright © 2015, Juniper Networks, Inc.
Chapter 7: Port and Interface Specifications