EasyManua.ls Logo

Juniper ACX5048 - Channelizing Interfaces

Juniper ACX5048
232 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 Gbps direct attach copper (DAC) cables
Ports 96 through 104 support:
40 Gbps QSFP+ transceivers
Additionally ports 96 and 100 support:
QSFP+ direct attach copper (DAC) cables
QSFP+ to SFP+ direct attach copper break out (DACBO) cables
QSFP+ to SFP+ fiber break out cables
See “Interface Specifications for SFP, SFP+, and QSFP+ Transceivers for an ACX5000
Router” on page 62 and “Interface Specifications for SFP+ DAC Cables for an ACX5000
Router” on page 77. All 96 of these ports can be used for SFP+ transceivers or SFP+
direct attach copper (DAC) cables. You can use 1-Gigabit Ethernet SFP+,
10-Gigabit Ethernet SFP+ transceivers and SFP+ direct attach copper cables in any
access port.
CAUTION: Do not place a copper transceiver in an access port directly above
or below another copper transceiver. Internal damage to the access ports
and routercan occur. We recommend either using thetop port row exclusively,
or bottom port row exclusively, for copper transceivers.
Channelizing Interfaces
The port panel of an ACX5096 supports up to a maximum of 104 logical 10 GbE ports
that can be distributed over 96 small form-factor pluggable plus (SFP+) and 8 quad
small-formfactorpluggable plus (QSFP+) transceivers. Because of an 104 port restriction,
only two of the eight QSFP+ can be channelized. Depending on how you set the system
mode for channelization, the behavior of channelization for the QSFP+ changes. The
following system modes are available for the ACX5096 router:
Non-oversubscribed
All 96 SFP+ ports on the router (PIC 0) are supported. In this mode, the eight QSFP+
ports are not supported and cannot be channelized. There is no packet loss for packets
of any size in this mode.
Default mode
All 96 SFP+ ports on the router (PIC 0) are supported. QSFP+ ports 96 and 100 can
be channelized. If ports 96 and 100 are channelized, the interfaces on ports 97, 98, 99,
101, 102, and 103 are disabled.
Related
Documentation
Access Port and Uplink Port LEDs on an ACX5000 Router on page 26
Copyright © 2015, Juniper Networks, Inc.22
ACX5048 and ACX5096 Universal Access Router

Table of Contents

Other manuals for Juniper ACX5048

Related product manuals