•
Rack-Mounting Requirements and Warnings on page 189
•
Ramp Warning on page 193
Intra-Building Ports Warning
WARNING: The intra-building ports of the equipment or subassembly are
suitable for connection to intra-building or unexposed wiring or cabling only.
The intra-building ports of the equipment or subassembly MUST NOT be
metallically connected to interfaces that connect to the OSP or its wiring.
These interfaces are designed for use as intra-building interfaces only (Type
2 or Type 4 ports as described in GR-1089) and require isolation from the
exposed OSP cabling. The addition of Primary Protectors is not sufficient
protection in order to connect these interfaces metallically to OSP wiring.
Installation Instructions Warning
WARNING: Read the installation instructions before you connectthe hardware
equipment to a power source.
Waarschuwing Raadpleeg deinstallatie-aanwijzingenvoordat u hetsysteem
met de voeding verbindt.
Varoitus Lue asennusohjeetennen järjestelmänyhdistämistävirtalähteeseen.
Attention Avant de brancherle systèmesur la sourced'alimentation, consulter
les directives d'installation.
Warnung Lesen Sie die Installationsanweisungen, bevor Sie das System an
die Stromquelle anschließen.
Avvertenza Consultarele istruzioni diinstallazioneprima dicollegare il sistema
all'alimentatore.
Advarsel Les installasjonsinstruksjonene før systemet kobles til strømkilden.
Aviso Leia as instruções de instalação antes de ligar o sistema à sua fonte
de energia.
¡Atención! Ver las instrucciones de instalación antes de conectar el sistema
a la red de alimentación.
Varning! Läs installationsanvisningarna innan du kopplar systemet till dess
strömförsörjningsenhet.
Rack-Mounting Requirements and Warnings
Ensure that the equipment rack into which the chassis is installed is evenly and securely
supported, to avoid the hazardous condition that could result from uneven mechanical
loading.
189Copyright © 2015, Juniper Networks, Inc.
Chapter 26: Installation and Maintenance Safety Information
To Next Page
Loading...
