NOTE: USB flashdrivesused with the ACX5000router must support USB 2.0
or later.
Console Port Connector Pinouts for an ACX5000 Router
The console port (labeled CON, C1, or CONSOLE) is an RS-232 serial interface that uses
an RJ-45 connector to connect to a console management device. The default baud rate
for the console port is 9600 baud.
Table 28 on page 58 provides the pinout information for the RJ-45 console connector.
An RJ-45 cable and RJ-45 to DB-9 adapter are supplied with the ACX5000 router.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to an ACX5000 router, use a
combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with the
router and a USB to DB-9 male adapter. You must provide the USB to DB-9
male adapter.
Table 28: Console Port Connector Pinouts for an ACX5000 Router
DescriptionSignalPin
Request to sendRTS Output1
Data terminal readyDTR Output2
Transmit dataTxD Output3
Signal groundSignal Ground4
Signal groundSignal Ground5
Receive dataRxD Input6
Data carrier detectDCD Input7
Clear to sendCTS Input8
Related
Documentation
Connecting an ACX5000 Router to a Management Console on page 121•
Management Port Connector Pinouts for an ACX5000 Router
The 1000BASE-T RJ-45 management ports use an RJ-45 connector to connect to a
management device for out-of-band management.
Copyright © 2015, Juniper Networks, Inc.58
ACX5048 and ACX5096 Universal Access Router
To Next Page
Loading...
