•
C0–Use the RJ-45connectors for 10/100/1000 BaseT. See“Connecting anACX5000
Router to a Network for Out-of-Band Management” on page 122.
•
C1–Use the SFP connector for 1000 BaseX.
•
USB port for image updates.
•
Console port (RJ-45) to support RS-232 serial ports.
Related
Documentation
Field-Replaceable Units in an ACX5000 Router on page 5•
• Chassis Status LEDs on an ACX5000 Router on page 23
• USB Port Specifications for an ACX5000 Router on page 57
• Connecting an ACX5000 Router to a Management Console on page 121
• Connecting an ACX5000 Router to a Networkfor Out-of-Band Managementon page122
Port Panel of an ACX5048 Router
The port panel of the ACX5048 supports up to a maximum of 72 logical 10 GbE ports
when operating as a standalone router. Forty-eight physical ports(0 through 47) support
10 Gbps small form-factor pluggable plus (SFP+) transceivers. These ports can be
configured as access ports. See “Interface Specifications for SFP, SFP+, and QSFP+
Transceivers for an ACX5000 Router” on page 62 and “Interface Specifications for SFP+
DAC Cables for an ACX5000 Router” on page 77. All 48 of these ports can be used for
SFP+ transceivers or SFP+ direct attach copper (DAC) cables. You can use 1-Gigabit
Ethernet SFP, 10-Gigabit Ethernet SFP+ transceivers and SFP+ direct attach copper
cables in any access port.
The remaining 24 logical ports are available for six 40 GbE ports (48 through 53) that
support up to six quad small-form factor pluggable plus (QSFP+) transceivers or QSFP+.
Each QSFP+ socket can operate either as a single 40 Gbps port or as a set of 4
independent 10 Ggps ports using QSFP+ breakout cables. The 40 GbE ports can be
configured as either access ports or as uplinks. See “Interface Specifications for QSFP+
DAC Breakout Cables for an ACX5000 Router” on page 82.
CAUTION: Do not place a copper transceiver in an access port directly above
or below another copper transceiver. Internal damage to the access ports
and routercan occur. We recommend either using thetop port row exclusively,
or bottom port row exclusively, for copper transceivers.
Figure 9 on page 21 shows the port panel of a ACX5048 router.
Copyright © 2015, Juniper Networks, Inc.20
ACX5048 and ACX5096 Universal Access Router
To Next Page
Loading...
